Step
1
Thoroughly
clean the application surface with pure alcohol prior to applying
UniGard TM
|
Step
2
A
squeegee is required to apply the product . Cover the
squeegee with a squeegee sleeve, or a soft protective cloth
to ensure the surface does not get scratched during the application |
Step
3
Wet
your fingers with the application fluid prior to removing
the liner. This will prevent the transfer of your fingerprints
to the adhesive.
|
Step
4
Remove
the liner and liberally spray the adhesive side of the film
application surface with the water /alcohol mixture
|
Step
5
Carefully
position UniGard TM
where desired. Using the squeegee,
work from the center and push the air and fluid out with the
overlapping strokes. Be firm, yet cautious , to avoid
creasing the film. If needed, UniGard can be lifted
up and repositioned. If repositioning is required, re
- wet the adhesive and take care not to stretch the film any
more than necessary.
|
|
Step
6
Remove
any bubbles using a pin
|
Note:
Patterns
can be made by applying paper application tape to the vehicle
and outlining the area with a pencil. remove the pattern
and place on a piece of UniGard
TM . Cut the pattern with
a razor or other sharp blade.
|
