Step 1 

Clean graphic area with soap and water.  If wax and grease remover needs to be used, re clean with soap and water

Step 2

Determine the position for the graphic by holding it up to the car. 

Step 3

Partially peel the backing off, to expose a foot or so of the adhesive.  At this point you may want to apply a spray of wetting solution under the graphic to make installation easier. 

Step 4

Lay down the leading edge just enough to hold down.  Stretch the length of the graphic out, peeling the adhesive as you go down the car.  Spray solution on the car under the entire kit.  Lay down the graphic at the other end, leaving a little tension on the kit. 

Step 5

Using a stiff squeegee or credit card , squeegee the entire kit in place, starting at the front and working your way back. 

If needed, lift  the back of the kit and re-tension it, lay it down again and continue to squeegee. 

Step 6

Peel of the premask as you watch the kit to see that it is staying in place.  If you used wetting solution to install the kit, you may have to wait 15 minutes until the water starts to dry. 

Step 7

With a sharp blade, lightly cut all the door openings.  Do this

carefully so that the paint finish is not cut.  It is best to trim the graphic 1/8" from all edges. 

Step 8

Check over the installation.  If you have any airbubbles, use a pin to punch the edge of the bubble so you can push out the air or water.